U-Line 2175BEVOL, Use And Care Manual

2175BEVS, 2175BEVOL

7

Figure 2

IMPORTANT

IMPORTANT

Proper air flow (Figure 2) is required for your unit to 
operate at its highest efficiently. A grille, located in 
the base of the unit, must not be blocked at any 
time, or your unit will not perform as expected.

Initial Startup

All U-Line units are shipped with controls that are preset. 
No initial adjustments are required. 

IMPORTANT

IMPORTANT

U-Line recommends the unit be allowed to run 
overnight prior to loading with product.

Figure 3

To turn the unit on or off, touch and hold the POWER icon 

(Figure 3, 1)

 on the display panel for approximately 10 

seconds until the °F symbol flashes and release.

• A small LED above the icon will illuminate to confirm 

the touch of any controller icon.

• The display 

(Figure 3, 3)

 will show the unit set-point 

temperature when the unit is on and will show OFF 
when the unit is off. 

• Turning the unit off will override any other control 

function.

Interior Lighting

The interior of the cabinet can be illuminated whenever 
the door is opened (default mode), illuminated for a four-
hour period, or remained darkened (blackout/Sabbath 
mode [not Star K certified]).

The LIGHT icon

 (Figure 3, 5)

 on the control panel is used 

to change the lighting functions.

To illuminate the interior of the cabinet for a four-hour 
period:

1. Touch and release the LIGHT icon 

(Figure 3, 5)

 to 

switch from door-operated lighting control to 
continuous lighting (the °F symbol will flash briefly 
after the LIGHT icon is pressed). 

2. To return to door-operated lighting control before the 

four-hour period is up, repeat Step 1. 

To turn the lights and display OFF (blackout/Sabbath 
mode [not Star K certified]):

1. Touch and hold the LIGHT icon 

(Figure 3, 5)

 for ten 

seconds and release (the °F symbol will flash briefly at 
the end of the five second period).

2. The interior light and control display 

(Figure 3, 3)

 will 

go dark.

NOTE: 

Although the display will not be visible, the 

temperature controls in the unit remain active, and the 
interior temperature will be maintained.

3. To exit the blackout/Sabbath mode (not Star K 

certified), repeat Step 1. 

Electronic Control Panel

Your Beverage Center has been designed to provide two 
temperature zones within the cabinet so the specific 
storage requirements of your beverages can be satisfied. 

Figure 4

The electronic control with digital display 

(Figure 4)

 is 

configured to show a single temperature continuously. 
This set-point temperature is a base number used by the 
controller to maintain the temperature zones in your unit. 
The factory default set-point temperature is 38°F. This set-
point temperature is used as a gauge if further 
temperature adjustments are required.

5 Operation

ULIN_0080_A

1

2

3

5

4

ULIN_0184a_A

1

2

3

5

4

ULIN_0184a_A

ULIN_016357_30172.fm  Page 7  Friday, February 2, 2007  11:45 AM