U-Line 2175RF, Use And Care Manual

U-Line Ice Makers

11

OFF

ON

2

1

7 Ice  Maker 

Ice Maker Adjustment

Ice Cube Thickness Adjustment.
Interval - As Required

On ice maker equipped models, adjust the cube size by changing 
water amount injected into the ice maker assembly as follows:

To turn off ice production:

 Raise the bin arm into an upright 

and locked position. The unit will preserve temperature for ice 
storage. 

IMPORTANT

IMPORTANT

If not intending to use the ice maker turn the water 
supply valve off, it is important to raise the bin arm of the 
ice maker (Figure 1). Failure to raise the bin arm may 
result in damage to the water valve.

Certain sounds are normal during the unit’s operation. You may 
hear the compressor or fan motor, the water valve, or ice 
dropping into the ice bucket.

WARNING

NEVER use an ice pick, knife or other sharp instrument 
to separate cubes. Shake the ice bucket instead.

During periods of limited use or high ambient temperatures, it is 
common for cubes to fuse together. Gently shake the bucket to 
break apart cubes. If not using the ice maker regularly, empty the 
ice bucket periodically to ensure fresh cubes.

It is normal for cubes to appear cloudy. The cause is air trapped in 
the water because of fast freezing. It is not caused by the health, 
taste or chemical make up of the water. It is the same air that is in 
every glass of water you drink.

Remove the ice bucket for emptying and cleaning. To remove the 
ice bucket, raise the bin arm and remove the bucket from the ice 
compartment. Use the ice bucket for ice storage only.

1. Remove the ice maker assembly cover (1).

2. Find the adjusting screw on the ice maker assembly control box 

(2). The adjusting screw is just below the minus (-) and plus (+) 
signs on the control box.

NOTE:

 Adjust in small increments. Too large of an adjust-

ment could cause the unit to malfunction.

CAUTION

Too large of an adjustment to the screw can cause the 
water to overflow the ice maker and can cause property 
damage.

3. Turn the adjusting screw toward the minus (-) sign (clockwise) 

for smaller cubes or toward the plus (+) sign (counterclockwise) 
for larger cubes.

4. Install the ice maker assembly cover.

Ice Maker Operation

When the ice bucket is full, the ice making mechanism will shut off. 
However, the refrigeration system will continue to cool and 
maintain the cube supply. Frost-free ice maker units have lower ice 
production than manual defrost units.

IMPORTANT

IMPORTANT

Do not place cans or bottles in the ice compartment 
because they will freeze.