PAGE 2 OF 5
0823 IH-10947
• This tool must be placed on its stand when
not in use; do not leave tool unattended
when switched on.
• Place tool on its stand after use and allow it
to cool down before storage.
• This tool is intended for use at altitudes not
exceeding 6,561'. Prior to making any repairs
on the glue gun, ensure that the glue gun
is at room temperature and that electrical
service lines have been discontinued. Failure
to disconnect the electrical power source
could result in electrical shock or damage to
the glue gun. Glue gun must be completely
assembled before connecting glue gun to
electrical outlet. Allow glue gun to cool to
room temperature before servicing. Failure
to do so may cause burns. Read instructions
before servicing.
CAUTION! Avoid contact with hot adhesive
and glue gun tip. This may cause burns. Wear
personal protective equipment per workplace
and industry standard operating procedures
when using, cleaning or charging tip. Keep tip
pointed away from body parts.
• Do not damage the back sleeve.
• Do not pull adhesive sticks from rear of glue
gun while in operation. Removing adhesive
from the rear may cause molten adhesive
flow out of the rear of the glue gun which
may cause burns and damage to the glue
gun.
• Use only 3M™ adhesive sticks. Other
adhesives may cause back melt and
possible injury. Use of other adhesives may
damage the glue gun or result in hazardous
conditions.
• Do not use low-temperature adhesives with
high-temperature glue guns.
• Reduce risks associated with hazardous work
positions to avoid minor or moderate injuries.
• Avoid raising the elbow, bending the wrist,
reaching and bending over when using this
device.
• Gently squeeze the trigger to push the
adhesive stick into the heat block. The
adhesive is melted by the heat block
and pushed out through the tip. A fixed
thermostat on the heat block maintains heat
block temperature.
NOTE: To avoid charring or plugging of the tip,
extrude at least one adhesive stick every three
hours that the glue gun is turned on.
• Do not overtighten. This could damage
threads.
SAFETY CONTINUED
OPERATION
WARNING! Use only 3M™ hot melt adhesive
TC or Q sticks. Other adhesives may cause
back melt and possible injury. Do not use near
highly flammable materials.
NOTE: TC sticks are 5/8 x 2", while Q sticks are
5/8 x 8".
NOTE: Use only a 110V-230V grounded
receptacle. Allow 6-10 minutes to heat up
before using.
WARNING! Tip and valve are hot. Keep tip
pointed away from body parts.
NOTE: To avoid charring or plugging of the tip,
extrude at least one adhesive stick every three
hours that the glue gun is turned on.
