PAGE 3 OF 8
0514 IH-3579
OPERATION CONTINUED
INSTALLING THE BRUSH OR PAD HOLDER
1. Align the lugs with
the corresponding
slots in the brush
or pad holder
and turn the brush
or pad holder
counterclockwise to
lock in place.
2. To remove brush/
pad holder, give it
a quick, hard turn
clockwise.
CAUTION! Using the wrong brush or pad on this
machine can damage the floor or overload
the motor.
OPERATION
1. Unwrap the power cord (5) and plug it into a
properly grounded outlet.
2. Pull up on the handle release compression lever (4).
Move the operator handle (6) downward until your
arms are almost straight. Push down on the handle
release compression lever (4) to lock it in place.
3. Lift up on the operator handle (6) until the brush (or
pad) is flat against the floor.
WARNING! Be prepared to control the machine
as soon as the motor starts.
Just a slight up or down movement of the handle will
make the machine move from side to side. Raise the
handle to go right. Lower the handle to go left.
CAUTION! Immediately start moving the
machine back and forth. Keep the machine
moving while the motor is running to avoid
damage to the floor or carpet.
4. Hold one of the operator hand grips (1) firmly, push
the safety lock button (2) and then compress the
switch levers (3) to start the motor.
NOTE: When the switch levers (3) are released,
the machine shuts off immediately.
NOTE: When spray buffing, check the pad
every 15 minutes for dirt and wax buildup.
If the pad is dirty, turn it over to expose
the clean side or install a clean pad.
WARNING! This machine contains moving parts.
To reduce the risk of injury, always unplug the
power cord before servicing.
AFTER USE
1. Place the operator handle (6) in the upright position
and unplug the power cord (5). Wrap the power
cord (5) around the operator handle grips (1) and
the cord hook (7).
2. Remove the pad holder or brush from the machine.
Clean the pad or brush and hang it up to dry. Allow
buffing pads to dry completely before using again.
Store brushes and pad holders separately from the
machine. Never store the machine with the pad
holder or brush on the machine.
3. Wipe the entire machine with a clean, damp cloth.
Wipe the underside of the brush housing after wet use.
4. Inspect the entire machine and all accessories for
damage. Perform any required maintenance or
repairs before storage.
5. Store the machine in a clean, dry place with the
operator handle (6) locked in the upright position.
Lugs
Slots
PARTS LIST
#
DESCRIPTION
1
Operator Handle Grips
2
Switch Lever Safety
Lock Button
3
Switch Levers: Squeeze
- ON / Release - OFF
4
Handle Release
Compression Lever
5
Power Cord
6
Operator Handle
7
Cord Hook
1
4
7
6
5
3
2
