CLR2160 — Clear Ice Maker
08/2006
3
www.U-LineService.com
General Precautions
Use this appliance for its intended purpose only and
follow these general precautions along with those listed
throughout this guide:
WARNING
SHOCK HAZARD — Electrical Grounding Required.
• Keep the unit unplugged throughout installation
except during testing.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
• Always keep your working area dry.
CAUTION
• Use care when moving and handling the unit. Use
gloves to prevent personal injury from sharp edges.
• Do not lift the unit by the door or door handle.
• Do not install the unit behind closed doors or in any
way that would obstruct airflow to the front grille,
which may cause the unit to malfunction.
You have received a carton containing your CLR2160 Clear
Ice Maker with a package inside containing a Use and Care
Guide, a Product Registration Card and water connection
parts. Complete and mail the Product Registration Card or
register online at www.U-LineService.com. Once your unit
is installed, keep the Use and Care Guide and this
Installation Guide in a safe place for future reference.
Your unit is Black, White or Stainless Steel. Black and
White units have a reversible door with a slightly
contoured handle across the top. They come with a flush
mounted door panel that, when removed, will accept a
custom 1/4-inch thick door panel or a 3/4-inch thick full
overlay door panel. Stainless Steel units are covered with
a protective coating and have been ordered left- or right-
hand hinged. The Stainless doors are not reversible and
do not accept custom panels. CLR2160 Clear Ice Makers
may be ordered with, or without, a factory-installed drain
pump. Please carefully follow the directions that apply to
your unit and your intended design.
Tools/Materials Required
• Screwdrivers — slotted and Phillips head
• 1/4-inch OD copper tubing and shut-off valve for water
supply line
• 5/8-inch ID drain line
• P60 Drain Pump (if required and not already factory
installed, see
Page
13
)
• 1/4-inch thick door panel material and cutting tools
(Black or White units) (If installing a 1/4” Panel Insert)
• Full Overlay Door Panel Kit (part number U-OL2115B —
Black or part number U-OL2115W — White), 3/4-inch
door panel overlay, cutting tools, drill and bits (Black or
White units) (If installing a 3/4” Full Overlay)
Inspection
Unwrap and inspect the unit on a flat, level surface
capable of supporting its entire weight.
Removing Protective Coating
(Stainless Steel Units Only)
When inspecting/installing a Stainless Steel unit, the
protective coating covering the unit must be removed
first. Start at a corner of the unit/door and pull back the
protective coating to remove it from the unit/door.
2 Inspect and Plan
