7
Setting CO
2
Pressure
To minimize foam for most beverages the pressure should be set between 8-12 PSI.
• Set the pressure by turning the handle on the front of the regulator counterclockwise until it is all the way out. This will
turn the regulator off.
• Turn the valve on the bottom of the regulator to the side to ensure no CO
2
will pass through the regulator.
• Pull the pin on the side of the coupler to release built up pressure from the keg. Open the faucet. Nothing should come
out initially as there is no pressure to the keg.
• Place a container under the faucet and open the valve on the bottom of the regulator.
• Turn the handle clockwise with the faucet open and your beverage will start to pour. Stop turning when you get the best
flow rate. This method should prevent your regulator from creeping.
If you are dispensing at altitude, you will need to increase your output pressure by one pound for every 2,000 feet of elevation
above sea level.
Handle
Valves
