70
Design
■
Features
■
Performance
TEMPERATURE CONTROL SPECIFICATIONS - DOUBLE
THROW ICE MAKER THERMOSTAT
These temperature controls use double throw, single pole relays. The sensing tube is inserted into the ice
maker mold and senses mold temperature. After ice is sensed in the mold, the contacts at pins 2 and 3
open (stopping the compressor and condenser fan motor) and the contacts at pins 2 and 1 close (starting
the ice maker motor). The 2-3 contacts change state before the end of the ice harvest cycle. This prepares
the control for the next cycle.
The compressor motor and the ice maker motor CANNOT operate at the same time because of the relay
contact configuration.
2
2
1
3
1
3
FREEZE POSITION
ICE HARVEST POSITION
CYCLE
CLOSED
CIRCUIT
OPEN
CIRCUIT
FREEZE
2 - 1
2 - 3
HARVEST
2 - 3
2 - 1
183-9
YELLOW WIRE
CONNECTION
RED WIRE
CONNECTION
BLUE/BLACK WIRE
CONNECTION
ICE MAKER CONTROL
2
1
3
183-8
BI
•
2015 MODEL
Summary of Contents for Echelon CO2075FF
