PHONE 1-800-295-5510
FAX 1-800-295-5571
WEB uline.com
Operating Instructions
Warning
1. Add a few drops of oil into the air inlet.
2. Install a quick connect fitting to the tool.
3. Regulate the air pressure to attain 80-100 psi.
4. Insert the staples into the tool following the loading instructions.
5. Reconnect the air hose to the tool.
6. Grasp the handle with one hand on box in line with the desired staple
location. There is a small projection on either side of the magazine seat as
an aid in locating the position of the staple.
7. The strongest closure requires staples close to the ends of the box.
Cleaning the Tool
Danger
1. Disconnect the Air Supply from the tool
2. Remove tar buildup with non-corrosive cleaner. Do not allow solvent to get
into the cylinder or damage may occur.
3. Dry the tool completely before use.
Never use gasoline or other flammable liquids to clean the stapler.
Vapors in the stapler could be ignited by a spark and cause the tool to explode.
1. Protect your eyes and ears. Wear:
a. Safety glasses with side shields
b. hearing protection.
Ensure that anyone in the vicinity wears safety protection.
2. To prevent accidental injuries never place a hand or any other body part in the staple
clinching area or adjustment window.
3. Never point the stapler towards you or anyone else.
4. Always handle the stapler with care. Never pull the trigger unless tool is ready for
operation.
5. Check and replace any damaged or worn components on the stapler.
CHICAGO
•
MINNEAPOLIS
•
LOS ANGELES
•
NYC/PHILA
•
ATLANTA
•
DALLAS
