PAGE 3 OF 30
0917 IH-1030
SAFETY INSTRUCTIONS CONTINUED
LOADING THE STAPLER
1. Disconnect the air supply.
2. Slightly squeeze the cover back, then pull the top
cover open. (See Figure 1)
3. Place coil staples in magazine. Feed front end
of coil staples into right coil guide, left coil guide
and top guide. Push forward until stopping in driver
guide unit. (See Figure 2)
4. Swing cover closed and squeeze to snap closed.
Check position engagement. (See Figure 2)
STAPLE LEG LENGTH
1. Loosen the set screw on the bottom with a 3mm
Allen wrench. (See Figure 3)
2. Adjust L/S screw with a screwdriver to the desired
setting. (See Figure 4)
a. If you are using 3/4" staples set L up.
b. If you are using 5/8" staples set S up. (See Figure 5)
3. Tighten the set screw on the bottom.
L
Figure 3
Figure 4
Figure 5
Figure 1
Figure 2
Set Screw
L /S Screw
