PAGE 5 OF 33
0913 IH-1619
CONTROL BOX CONTINUED
LED DISpLAy
EO
Emergency Stop Condition
- -
System is normal
A
Mode A Selected
B
Mode B Selected
CO
Continue operation by pushing START button
S
System is in Manual
BUTTONS
WRAPPING MODE A - WRAP UP AND DOWN
The LED on the button’s upper left is on. In Mode A, the bottom wrap is applied first, and then the
top wrap follows. The film carriage comes down to its home position after wrapping cycle is
finished.
WRAPPING MODE B - WRAP UP ONLY
The LED on the upper left is on. In Mode B, after a bottom to top wrapping is completed, the
carriage stays on the top. The START button flashes at this point. To resume the operation, push
START. When the carriage reaches the bottom, the START button turns off. Push START button again
to begin a new cycle.
The TURNTABLE JOG button allows you to manually operate the turntable. When this button is
pushed, the light on the button’s upper left is on. Push START button to run the table. Pushing the
button again will stop the turntable and the light will turn off. This button may be used in
conjunction with the CARRIAGE JOG button.
The CARRIAGE JOG button allows you to manually operate the carriage. When this button is
pushed, one of the lights on the button’s upper right or left is on. The upper left light indicates that
the carriage will go up when the START button is pushed. Conversely, the upper right light
indicates the carriage will go down when the START button is pushed. To pause operation, simply
push this button again. Both indicator lights will go off. This button may be used in conjunction
with the TURNTABLE JOG button.
Push this RESET button, followed by the START button, to reset the system. The turntable will return to
its home position and the carriage will lower.
Push the TOP WRAPS button to select the number of top wraps desired (0 - 9).
