PAGE 3 OF 12
0922 IH-1679-MNBRD
4. Insert colored wires into termination block. Reference
photo taken on step 8 of Mainboard Removal.
Tighten screws using 3 mm screwdriver. (See Figure 13)
NOTE: Gently tug on wires to ensure proper
installation.
5. Screw on cord grip cap to secure main wire to
junction box. (See Figure 14)
6. Replace and secure junction box faceplate
using four previously removed screws and Phillips
screwdriver. (See Figure 15)
7. Replace front panel and secure with two previously
removed Phillips head screws. (See Figure 16)
8. Reconnect four-pin connector to mainboard.
(See Figure 17)
9. Replace previously removed red caps onto
mainboard.
10. Slide mainboard over posts on indicator faceplate.
Secure using previously removed nuts and
7 mm socket wrench. (See Figure 18)
IMPORTANT! Check button and board
functionality after tightening nuts. Buttons may
not function if nuts are too tight or too loose.
INSTRUCTIONS CONTINUED
Figure 13
Figure 17
Figure 18
Figure 16
Figure 15
Figure 14
Cord Grip Cap
