PAGE 2 OF 5
0714 IH-2243
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – switch off power
and allow the top heater to cool down before
performing any cleaning, maintenance or
repair.
Follow all safety and operating instructions contained in
this manual. check state and local safety and
electrical codes.
Tape dispenser is for use with gummed tape OnlY. Uline
accepts no responsibility for damage due to
improper use.
Keep the machine clean, dry and in good operating
condition. DO nOT place or operate machine in damp
or humid environments.
WARNING! Avoid short circuits and do not
disassemble the batteries.
WARNING! Do not expose batteries to flames,
fire or excessive heat.
WARNING! Do not dip the battery in water and
do not expose it to high humidity.
InSTAll WATER RESERVOIR
Before using the dispenser: Wash the moistening brush
with soap and water. Rinse thoroughly.
1. Insert the brush in the water reservoir. (See Figure 1)
2. Switch power on.
3. While holding down the green Random length
button, take the reservoir in your left hand and
insert the pivot shaft into the slots on the sides of the
dispenser. Move shaft up to the top of the slots.
(See Figure 2)
4. Slide reservoir down so bottom fits over tab
on dispenser.
5. Release the green button.
InSERTInG THE BATTERY
1. Insert the battery by sliding it in it’s location on the
water bottle side.
cHARGInG THE BATTERY
1. connect the battery charger into an electric supply
and insert battery until it locks into position.
2. The lED placed on the feeder indicates the battery
charge status: red lED, battery under charge; green
lED, battery charge completed.
3. After approximately 60 minutes it is possible to verify
the charge status of the battery. As it does not have
the ‘memory’ effect this battery can be re-charged
at every charge stage.
REMOVInG THE BATTERY
1. Press the button placed on the upper part of the
battery fix plate and remove battery by sliding it out
of position.
FIll WATER BOTTlE
1. Remove bottle from brackets and turn over so filler
opening faces up. (See Figure 3)
NOTE: If bottle is not empty, cover the filler
opening to prevent spills.
2. Fill bottle with clean water. cover the filler opening
to prevent spilling, turn bottle over and place filler
opening over desired water level peg in the water
reservoir. (See Figure 4)
NOTE: Adjust reservoir level: To maintain the
optimum moisture level for the type of tape
you are using, place the water bottle filler
opening over one of the three water level pegs
in the water reservoir.
GENERAL INFORMATION
sET-UP INsTRUCTIONs
Figure 1
Figure 2
