PAGE 6 OF 8
1214 IH-2289
OPeratiOn COntinueD
referenCe weight COntinueD
ESTABLISHING A NEW REFERENCE WEIGHT
The display shows Put.rEF %.
1. To establish the reference weight,
place the sample on the scale
and press the FUNCTION MODE
button to capture the weight. rEF.
Wt is displayed shortly followed by
the value with the current unit of
measure.
BEGIN PERCENT WEIGHING
1. Place the sample on the scale
and read the percent value. If a
container is used, be sure to tare
the empty container first.
CheCK weighing
Use this mode to determine if
the weight of a sample is within
prescribed limits.
CheCK weighing limits
When the FUNCTION MODE button is
released, CLr.rEF is displayed.
CLEARING STORED CHECk WEIGHING LIMITS
1. Press the YES button to clear the stored limits.
RECALLING STORED CHECk WEIGHING LIMITS
1. Press the NO button to recall the stored limits.
nOte: Press the
FUNCTION
MODE
button to temporarily
display the under and over
limit values.
EDITING THE UNDER SETTING
1. The display shows SEt.LO. Press the
YES button to edit setting.
Settings:
-999950 to 999950
Refer to Menu Navigation
to enter settings.
nOte: the minus sign is used
together with the first digit to
show a negative value.
EDITING THE OVER SETTING
1. The display shows SEt.HI. Press the
YES button to edit setting.
Settings:
-999950 to 999950
Refer to Menu Navigation
to enter settings.
Begin CheCK weighing
The appropriate under, accept or over
LED lights indicate check weigh status.
1. Place a sample on the scale and
read the weight.
2. For loads less than the under limit,
the yellow under LED is lit.
3. For loads greater than the under
limit and less than the over limit, the
green accept LED is lit.
4. For loads greater than the over
limit, the red over LED is lit.
DynamiC weighing
Use this mode to weigh moving or
oversized objects. The weight is held
on the display until reset. Manual,
semi-automatic and automatic start/
stop methods are available.
Begin DynamiC weighing
1. When the display shows rEAdY,
place the object on the scale.
2. If the manual mode is in use,
press the FUNCTION MODE button
to start measurement. If the semi-automatic or
automatic mode is in use, measurement is started
automatically.
CLr.rEF
kg
110.000
kg
120.000
kg
SEt.LO
kg
SEt.HI
kg
kg
CHEC
rEAdY
. O.000
kg
. O.123
kg
. 1
1
1.234
kg
.
122.345
kg
dYNA
kg
. 100.00
%
12.345
kg
Put.rEF
%
rEF. t
kg
kg
to
