0411 IH-2957
PAGE 1 OF 17
H-2957
AUTOMATIC STRETCH
WRAP DISPENSER
SYSTEM SPECIfICATIONS
MACHINE DIMENSIONS
Length
116"
Width
65"
Height
92"
Turntable Diameter
65"
Turntable Height from Floor
3 1/4"
Wrapping Height
80"
Operation Space
125 x 70 x 100"
Maximum Load Size
56 x 56 x 80"
Approximate Shipping Weight
1220 lbs
ELECTRICAL SPECIFICATIONS
• 120 VAC, 60 Hz, Single-phase, 15 AMP
• NEMA-12 rated electrical panel
• Operating temperature: +32˚F to +110˚F
• Lockable disconnect switch
• NEC wiring standard
• Programmable Logic Controller (PLC) with input/
output diagnostic lights
TURNTABLE SYSTEM
• Low Profile: ½ HP 3-phase AC motor, ½ HP AC
frequency drive
• 20-30 loads per hour (spiral)
• 12 RPM turntable maximum speed
• 4,000 lbs turntable maximum load capacity
FILM CARRIAGE / ELEVATOR SYSTEM
• ½ HP 3-phase AC motor, ½ HP AC frequency drive
• Adjustable raise and lower speeds
• Automatic height detection photoelectric sensor
FILM DELIVERY SYSTEM
• ¼ HP 3-phase AC motor, ½ HP AC frequency drive
• Adjustable film force
• 200% / 250% average pre-stretch level
• 10" diameter roll capacity
• 20" height roll capacity
CAUTION! Motor control equipment and
electronic controllers are connected to
hazardous line voltages. When servicing
drive and controllers, there may be exposed
components with housings or protrusions at or
above line potential. Extreme care should be
taken to protect against shock.
The user is responsible for conforming to all
applicable code requirements with respect
to grounding all requirements. Do NOT use
extension cords to operate the equipment.
Disconnect AC input power before checking
components, performing maintenance,
cleaning up, and when the machine is not in
use. Do NOT connect or disconnect wires and
connectors while power is applied to circuit.
Wiring work should be carried out only by
qualified personnel. There is a danger of
electric shock or fire.
WARNING! Loose clothing must NOT be worn
while the machine is in operation. Stay clear of
moving parts while the machine is running.
