background image

PAGE 1 OF 14 

1221 IH-2961

π

  H-2961, H-2962

DRUM HEATER

1-800-295-5510

uline.com

INSTRUCTIONS

SAFETY

A safety alert symbol is used to call attention to 

instructions concerning user's personal safety. Read 
the message that follows the symbol and be alert to 
the possibility of personal injury or death: 

DANGER! Immediate hazards will result in 
severe personal injury or death. 

•  A person who has not read and understood all 

operation instructions is not qualified to operate this 

product. 

• Do not immerse heater in liquid. 

•  Keep volatile or combustible materials away from 

heater when in use. 

• Keep sharp objects away from heater. 

•  Do not modify this product. Modification will void 

warranty and could lead to personal injury or death. 

WARNING! Hazards or unsafe practices that 
could result in severe personal injury or death. 

•  Only qualified personnel are allowed to connect 

electrical wiring. 

•  Disconnect all power at the source before making 

any power connections. 

•  All electrical wiring must follow local and national 

codes. 

•  The person who performs the final installation or 

wiring must be qualified for this work. 

•  User is responsible for providing a suitable 

disconnecting device. 

•  User is responsible for providing suitable electrical 

protection devices. It is highly recommended that  

a ground fault circuit breaker is used. 

•  Consult proper authorities for information for safe 

heating of materials of any vessel being heated.

CAUTION! Hazards or unsafe practices that 
could result in personal injury or property 
damage. 

•  Do not apply power to heater prior to proper 

installation. Disconnect power supply to heater 
before removing the heater from installation. 

•  Never handle the heater while it is in operation. 

Always disconnect the heater from the power source 

and allow to cool prior to handling. 

•  Never operate heater without a temperature control 

device. 

• Inspect heater before use. 

• Do not wrap the heater over itself. 

•  If spillage of foreign matter onto heater occurs, 

disconnect from power source and clean after heater 

is allowed to cool. 

•  Never operate without an appropriate heat sink 

(device being heated is considered a heat sink). 

•  Do not operate heater above the rated temperature 

value. 

•  Do not attempt to repair a damaged or faulty heater. 

•  Do not crush, fold or apply severe physical stress onto 

heater or cord assembly. 

• Disconnect heater when not in use. 

•  When cool, heater should be rolled for convenient 

storage and placed in original packaging. 

•  Use specified heater with corresponding drum size. 

Do not use for other applications. 

WARNING! Read these instructions before installing, operating or servicing this product. Failure to 
understand these instructions could result in an accident causing serious injury or death.  

Para Español, vea páginas 5-9.

Pour le français, consulter les pages 10-14.

Summary of Contents for H-2961















Reviews: