background image

0312 IH-3405

PAGE 1 OF 7

ELECTRIC PALLET TRUCK

1-800-295-5510

uline.com

H-3405

GENERAL SAFETY GUIDELINES

WARNING! Do not operate this truck unless you 

have been trained to use it, authorized to do so 
and have checked it is in good condition. The 

operator should read all of the warning signs and 

instructions here and on the truck before using it. 

The truck is strictly forbidden to lift or carry a person.

NOTE: Battery must be charged prior to first use.

1.  In case of any failure or fault, please stop using the 

truck until it can be properly repaired. 

2.  Do not repair the truck without professional training 

and authorization. 

3.  Protective shoes should be worn when working  

with this truck according to local safety regulations. 

4.  Keep a two-foot distance between the truck and 

any person not operating it. 

5.  Never place any part of your body in the lifting 

mechanism or under the forks or bed.

6.  Do not operate on uneven ground or in a 

dangerous environment.

7.  The truck should not be driven on public roads.

8.  The truck may only be driven into an elevator or 

loading platform with enough load capacity to 
support the truck. The operator must confirm this 
point before entering elevator or loading platform. 
Passengers must enter the elevator after proper 
parking of the truck and walk out of the elevator 
before moving the truck.   

9.  The truck should always be driven with the height of 

the forks in the lowest position except when placing 
or moving a load. 

10.  The truck should always be parked on a level 

surface. The forks must be lowered to their lowest 
position. Always turn the ignition to the "OFF" position. 

Always remove the ignition key from the electrical 

lock when leaving the truck. 

11.  The truck should not be modified in any way from its 

original form. 

12.  Safe operating temperature range: 41–104° F.

13.  Charge battery in a dry, well-ventilated area and 

keep away from any source of fire.

TRUCK ON ANOTHER VEHICLE'S LOADING  

PLATFORM OR ON A GANGWAY

1.  Before the truck is driven from a loading bay and 

onto a vehicle, the operator must always check the 
maximum load capacity of the gangway. There 
should also be suitable devices that prevent the 
gangway from sliding. 

2.  The operator must also check the maximum load 

capacity of the vehicle. There should also be 
suitable devices to prevent the vehicle from moving. 

TRUCK ON A RAMP OR INCLINE

1.  The forks of the truck should always face the 

up-slope direction.

2.  Never turn around or turn the truck sideways on a 

ramp.

ROUTINE CHECKLIST BEFORE START-UP

 —   

Check for any defect of the truck (especially on the 

wheels). 

 —   

Check if battery is fixed firmly and cable connected 

properly.

START-UP OF TRUCK

 —  

Pull out emergency shut-off switch.

 —   

Insert key into electric lock switch and turn clockwise 

to position 

"

I

".

 —   

Battery capacity meter should indicate the current 

capacity.

 —  

Check to ensure the horn is working correctly.

 —  

Check the brake function on the control handle.

OPERATING INSTRUCTIONS

Summary of Contents for H-3405








Reviews: