0621 IH-5164
PAGE 3 OF 12
ASSEMBLY CONTINUED
Figure 6
Figure 7
Figure 8
Figure 9
7. Lay the table legs and table leg braces down flat
on the table top. (See Figure 6)
8. Place a sliding end cap on each end of one of the
tubes on the table legs. (See Figure 6)
9. Place a bench seat underneath one of the legs and
slide the sliding end caps under the glide rails of the
bench seat. (See Figure 7)
10. Attach two sliding end caps to the tube on the other
table leg, and lift the bench seat upward until the
sliding end caps rest inside the underside of the
bench. Position the bench so all four sliding end
caps are under the glide rail. (See Figure 8)
11. Repeat steps 8-10 for the second bench seat.
12. Lift one leg assembly upright and hold it in place. A
second person will rotate the diagonal supports of
the leg brace assembly until the locking pin snaps
into the notches located at the end of the diagonal
supports. Connect the ends of the diagonal
supports to the leg assembly using two bolts and
two locknuts. (See Figure 9)
13. Repeat step 12 for the second leg brace assembly.
Sliding
End Caps
Screws
Screws
Sliding
End Cap
Glide Rails
Sliding
End Caps
Glide Rails
Locknuts
Bolts
Diagonal
Supports
Locking Pin
