U-Line H-5333, Manual

PAGE 1 OF 13 

0621 IH-5333

H-5333

1-800-295-5510

uline.com

AUTOMATIC PAPER 

CRUMPLER – FLOOR STANDING

TOOLS INCLUDED

TOOL NEEDED

1/8"

9/16" Wrench

7/32"

1/4"

5/16"

Allen Wrench

1.  Remove all parts from the three shipping cartons.

2.  Position floor base on a flat surface.

3.  Lock all casters by stepping down on black plastic 

locks to secure the base during assembly.  

(See Figure 1)

4.  Position tubular center bar so the single hole is at 

the top of the beam and facing the short side of the 
floor base. (See Figure 1)

5.  Line up two holes at the bottom of the tubular center 

bar with the holes in the middle of the floor base. 
Secure with 3/8-16 x 5" bolts, 3/8 lock washers, and 

3/8-16 nuts (2 each). (See Figure 1)

6.  From back of unit, line up the two tubular stabilizer 

bars to the back cross sections of the floor base. The 

welded nuts at the top should be facing the short 

side of the base. (See Figure 2)

7.  Secure the two tubular stabilizer bars to the floor 

base using 3/8-16 x 3.5" bolts, 3/8 lock washers, and 

3/8-16 nuts (4 each). (See Figure 2)

NOTE: Lay floor base on its side. Start with the 
bottom bolt. Bolts should be inserted from the 
back of the unit and secured between the two 

cross sections of the floor base.

Figure 1

Tubular 

Center Bar

Floor Base

Locked

Figure 2

Tubular  

Stabilizer Bars

Para Español, vea páginas 5-9.

Pour le français, consulter les pages 10-13.

ASSEMBLY