PAGE 4 OF 12
0620 IH-725
LOAD TAPE ROLL CONTINUED
2. Reposition the roller for gummed in or gummed
out tapes.
3. Insert tape roll between guide plates and over roller
so tape is positioned gummed side down. Feed the
tape under the upper paper guide and white wheel.
(See Figures 10A & 10B)
SETUP INSTRUCTIONS CONTINUED
GUMMED
OUT
Figure 10A
GUMMED
IN
Figure 10B
CAUTION: Only trained personnel should be
allowed to operate or service this machine.
WEEKLY MAINTENANCE
Wash the moistening brush with soap and warm water.
Rinse thoroughly with water.
MONTHLY MAINTENANCE
1. Lubricate the cutting blades with a drop of oil.
2. Wash the rubber wheel with water. Do not grease or
oil the wheel. Access the wheel by removing the
upper paper guide.
3. Clean the water reservoir with soap and water.
Rinse thoroughly.
OPERATION
1. Pull feed lever forward until the lever cam points to
the desired tape length on the BLACK scale.
NOTE: Pull the lever with even pressure – Do not
yank it. (See Figure 11)
2. Release the lever to automatically cut the tape – Do
not push the lever back.
NOTE: To cut very short lengths (4-8"), you may
have to push the lever back gently.
3. To preset a second tape length: (for ‘H' closings,
different box sizes, etc.): Loosen the clamping nut
and set the lever cam to point to the desired length
on the RED scale.
NOTE: When using two lengths, the longer
length should be set on the RED scale.
MAINTENANCE AND CARE
OPERATION
OPERATION
Figure 11
Feed Lever
Set Cam
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com