PAGE 2 OF 3
0519 RH-8041
MAINTENANCE
DAILY MAINTENANCE
1. Empty the dirty water tank. (See Figure 9)
2. Clean the dirty water tank. (See Figure 10)
3. Check the dirty water tank float is undamaged and
clean and moves freely on the pin. (See Figure 11)
4. Clean the brush (See Figure 12)
5. Check the squeegee is clean and the blades are
not damaged. (See Figure 13)
6. Check the battery charge. (See Figure 14)
7. To recharge the batteries, plug in the battery
charger using the electrical cord provided with the
machine. (See Figure 15)
REPLACING THE SQUEEGEE BLADE
• Release the clip.
• Remove the two blade retainers by pushing them to
the outside of the squeegee then extracting them.
• Remove the blade.
• Reuse the same blade by reversing the edge in
contact with the floor until all four edges are worn
out, or replace with a new blade, fitting it into the
screws of the body of the squeegee.
• Reposition the two blade retainers by centering the
widest part of the slots over the fixing screws on the
squeegee, then pushing the blade retainers inward.
• Fasten the clip.
CHECK MOTOR FUSES
1. Drain the recovery tank. Remove the recovery tank
by lifting up. (See Figure 15)
2. Locate fuse. (See Figures 16 -17)
3. Remove the vacuum or brush fuse. (See Figure 18)
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 15
Brush motor fuse.
Vacuum motor fuse.
Figure 16
Figure 17
Figure 18
