PAGE 3 OF 3
0519 RH-8041
OPERATING ISSUE
RECOMMENDATIONS
The machine does not start.
Check the battery charge.
The suction motor does not work.
Check the dirty water tank is not full.
Check the dirty water tank lever sensor is not blocked/
malfunctioning.
Check vacuum motor fuse. (See Check Motor Fuses on page 2)
The machine leaves the floor wet.
Check the squeegee blades are not worn.
Check there is no debris between the squeegee blades.
Check there is no debris in the suction hose.
Check the suction filter is undamaged and clean.
The machine leaves stripes of wet floor.
Check the floor has been swept before using the machine.
Check there is no debris between the two squeegee blades.
Check the squeegee blades are not worn.
Check squeegee is correctly adjusted.
Brush motor will not start.
Check brush motor fuse. (See Check Motor Fuses on page 2)
The brush motor thermal cutout has
tripped; the motorhead has overheated.
Release the brush lever button (LED off) and leave the machine
to cool down for at least 45 minutes.
TROUBLESHOOTING
MAINTENANCE CONTINUED
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
4. Check the fuse to see if it is blown by looking in the
fuse window. If the metal wire is present and not
broken, the fuse is good. If the metal wire is missing
or broken, the fuse is bad and needs to be replaced
with a new fuse. (See Figures 19-20)
5. Install a new fuse, and reattach the fuse cover.
Replace tank back on and test. (See Figure 20)
AUTOMATIC BRUSH REPLACEMENT
• Attaching: insert the brush under the head, activate
the drive lever until it is attached.
• Releasing: tilt machine back, activate drive lever
and release
Figure 19
Figure 20
