PAGE 6 OF 24
0721 IH-9235
IF USING BARRELS (H-9247)
1. Turn the barrel upside down to connect the
mounting plate. (See Figure 26)
a. Put a 5/8" washer (1) over the nut and bolt.
b. Place the mounting plate (2) over the washer.
c. Place another 5/8" washer (3) followed by a
3/8" washer (4).
d. Place and tighten the 3/8" nut (5).
e. Flip the barrel right-side up and insert the base
plate (6) through the hole in the plate.
2. Place a pole over the base plate that has been
inserted into the plate. Put bail pin (7) through pole
and base plate to secure. (See Figure 27)
NOTE: Attach strap at bottom of barrel before
filling barrel with water. (See Figure 28)
3. To connect the strap to eye bolt in bottom of barrel,
pull looped strap through the eye bolt. Take the
other end of strap and pull it all the way through the
loop. Pull long end tight to secure strap to eye bolt.
(See Figure 29)
4. Pull strap through cover slit. (See Figure 30)
5. Connect the opposite end
of the strap to the fitting
at the top of the pole,
not
around the tent frame
poles.
This forms a strong
triangle. (See Figure 31)
6. Fill barrel with water.
ASSEMBLY CONTINUED
Figure 30
Figure 28
Loop
Strap
Barrel
Figure 29
Figure 31
Figure 27
Bail Pin
Figure 26
2
7
3
1
4
5
6
