PAGE 18 OF 69
1021 IH-9554
MAINTENANCE
CLEANING
The housing may be cleaned with a cloth dampened
with a mild detergent if necessary. Do not use solvents,
chemicals, alcohol, ammonia or abrasives to clean the
housing or control panel.
TROUBLESHOOTING
Table below lists common problems and possible
causes and remedies.
If the problem persists, contact contact Uline Customer
Service at 1-800-295-5510.
SYMPTOM
POSSIBLE CAUSE
REMEDY
Cannot turn on
No power to scale
Verify connections and voltage.
Poor accuracy
Improper calibration
Unstable environment
Perform calibration.
Move scale to suitable location
Cannot calibrate
Unstable environment
Incorrect calibration weight
Move the scale to suitable location.
Use correct calibration weight.
Cannot access mode
Mode not enabled
Enter menu and enable mode.
Cannot access unit
Unit not enabled
Enter menu and enable unit.
Battery icon flashing
Battery is empty
Connect the scale to AC power and charge the battery.
Err 8.1
Power on error
Weight reading exceeds Power On Zero limit.
Err 8.2
Power on error
Weight reading below Power On Zero limit.
Err 8.3
Over range error
Weight reading exceeds Overload limit.
Err 8.4
Under range error
Weight reading below Underload limit.
Err 8.5
Tare out of range
Adjust tare value to be within range.
Err 8.6
Display overflow
Weight exceeds six digits.
Err 9.5
Calibration data error
Calibration data not present.
-------
Busy
Displayed during tare setting, zero setting and printing.
--NO--
Action not allowed
Function not executed.
CAL E
Calibration error
Unstable environment
Incorrect calibration weight
Calibration value outside allowed limits.
Move the scale to suitable location.
Use correct calibration weight.
Lo.AEF
Low reference weight warning
Increase reference weight.
rEF.Err
Unacceptable reference weight
Reference weight too small.
Weight on the pan is too small to define a valid
reference weight. Increase reference weight.
NO.ACC
Gross and net weights cannot be accumulated
together
Only accumulate gross or net weights
(only works in LFT).
Battery fails to charge fully
Battery is defective
Call Uline Customer Service at 1-800-295-5510 to
replace battery.
SERVICE INFORMATION
If the troubleshooting section does not resolve or
describe problem, contact Uline Customer Service at
1-800-295-5510.
