10
u-line.com
SS1095
Reversing the Door
Depending upon the location of the unit, it may be desirable to
change the side on which the door is mounted.
To reverse the door mounting, perform the following:
1. Remove grille (one screw) (
Figure 19
).
2. Remove top hinge from cabinet (three screws) (
Figure 20
).
Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove bottom hinge from cabinet (two screws) (
Figure 21
).
5. Remove screws on opposite side of cabinet (
Figure 22
).
6. Install hinge on opposite side, bottom of cabinet (
Figure 23
).
Align hinge outer edge with cabinet before tightening screws.
7. Relocate plastic spacer/bushing (
Figure 24
) on top and bottom
of door to opposite side. Clean out bushing hole in door bottom
with a screwdriver if necessary.
8. Using a Phillips screwdriver, remove the two screws holding the
custom stainless handle from the original location, and remove
the handle. Remove the two screws on the opposite side of the
door (
Figure 25
). Do not place handle on door until you have
completed, steps 9 & 10.
9. Remove plastic hole plug (
Figure 26
) from door handle and
relocate on opposite side. Lift the handle slightly and press on
the locking tab, then gently pry the hole plug out of the hole
being careful not scratch the top cap.
10. Relocate plastic spacer/bushing on top of door that was
underneath the hinge to the opposite hole in top cap
11. Attach handle removed in
Step 7
to opposite side of door
frame. Be sure to tighten all four screws removed in
Step 7
.
12. Remove pivot screw from top hinge, invert screw and reinstall
pivot screw in top hinge (
Figure 27
).
Mod el
SS1095FC
Mod el
SS1095FD
Grille
screw
19
Hinge screws
20
21
22
23
1
24
25
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
26
Press in locking tab, then
lightly pry up to remove hole
plug and move to opposite
side
27
