PAGE 4 OF 54
0521 IH-5276
SPAN CALIBRATION (SINGLE POINT)
Span calibration uses two calibration points, one at
zero
load
and the other at
specified full load
(span).
NOTE: Factory default settings are shown in bold.
With the balance turned on and no load on the pan,
touch
SPAN CALIBRATION
to initiate the procedure.
Additional calibration values to be used are shown on
the display. The best accuracy is achieved using the
mass closest to the full span value.
NOTE: To change the span calibration point,
touch the alternate weight shown on the display.
Follow the screen instructions and place the
specified calibration weight on the scale when
prompted to do so. When complete, the display
shows the span calibration status and returns to
the current application.
LINEARITY CALIBRATION (MULTI-POINT)
Linearity calibration uses three calibration points, one
at zero load and the others at specified loads. With
no load on the scale, press
LINEARITY CALIBRATION
to
begin the process. The balance captures the zero point,
and then prompts for the next weight. Continue to follow
the instructions on the display until the calibration is
completed.
NOTE: To cancel at any time, press CANCEL.
CALIBRATION TEST
Use Calibration Test to compare a known calibration
weight against the stored span calibration data.
With no load on the scale, press
CAL TEST
to begin the
process. The balance captures the zero point, then
prompts for the span value.
The display shows status, followed by the difference
between the current calibration weight and the stored
calibration data.
ZERO
Press
ZERO
to zero the balance.
TARING
With no load on the pan, press
ZERO
to set the display
to zero. Place an empty container on the pan and press
TARE
. Add material to the container and its net weight
is displayed. Remove container and container's weight
appears as a negative number. Press
TARE
to clear.
APPLICATION MODES
Touch the top left application field (weighing in the
example below) to select the application mode.
(See Figures 4-5)
NOTE: Before using any application, be sure
the balance has been leveled and calibrated.
WEIGHING
Use this application to determine the weight of items in
the selected unit of measure.
1. In the upper left portion of the home screen,
(See Figure 6) select
WEIGHING
(this application is
the default).
2. Press
TARE
or
ZERO
if necessary to begin.
3. Place objects on the pan to display the weight.
When stable, the * appears.
4. The resulting value is displayed in the main display
line in the active unit of measure.
OPERATION CONTINUED
Weighing
Menu
Save to
USB
Item
Settings
Sample
Name
639.77 g
0.00 g
Gross:
Tare:
4200 g
Capacity Guide
639.77
g
Max 4200 g
d=0.01 g
15%
Figure 4
Figure 5
Figure 6
Application Modes
Weighing
Parts Counting
Percent Weighing
Display Hold
Dynamic Weighing
More...
Check Weighing
Density
Determination
Exit
Back
Weighing
Menu
Save to
USB
Item
Settings
Sample
Name
0.00 g
0.00 g
Gross:
Tare:
4200 g
Capacity Guide
>0<
0.00
g
Max 4200 g
d=0.01 g
0%
The WEIGHING
home screen
Main Display Line
Touch
g
to
change unit
Application
Buttons
Reference Fields
