www.U-LineService.com
6
02/2005
75R, 75WC and 75BEV Models
Reversing the Door
(75R Units Only)
All units may be left- or right-hand opening (75BEV units
cannot be field-reversed).
Black and White 75R Units
Note:
The grille should not yet be installed. If it has been
installed, remove it for door reversing. See
Page
11
.
To reverse the door on Black or White 75R Refrigerator
models:
1. Remove top hinge from cabinet (four screws). See
Figure 4
. Hold door to keep it from falling.
2. Lift the door off the bottom hinge.
3. Remove four plastic plugs in hinge holes, top of cabinet,
opposite side. See
Figure 5
.
Be careful not to scratch
cabinet.
4. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See
Figure 6
. Do not
install hinge on cabinet at this time.
5. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet. See
Figure 7
.
6. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge. See
Figure 6
.
7. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit. Partially
tighten screws. See
Figure 8
.
8. Relocate plastic spacer/bushing on bottom of door to
the opposite side. See
Figure 9.
Clean out bushing hole
in door bottom if necessary.
9. Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws). Partially tighten screws until door
is aligned. See
Figure 10
.
10. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
11. Replace four plastic plugs removed in Step 4 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
Figure 4
Figure 5
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
Figure 6
Figure 7
Figure 8
B
us
hi
n
g
Figure 9
Figure 10
