QUICK START GUIDE
u-line.com
25
First Use
CRESCENT ICE MAKERS
Initial startup requires no adjustments.
U-Line recommends discarding the ice produced during the
first two to three hours of operation to avoid possible dirt
or scale that may dislodge from the water line.
To turn the unit on or off:
Press the rocker switch located inside the door on the front
panel, or behind the grille.
REFRIGERATORS
Initial startup requires no adjustments. If the unit was
turned off, press and hold for 5 seconds to turn unit on.
See “Control Operation” section for more details.
Temperature displayed reflects actual
temperature inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
CONVERTIBLE FREEEZER
Initial startup requires no adjustments. If the unit was
turned off, press and the unit will immediately switch
on. To turn off press and release. See CONTROL
OPERATION section for more details.
Temperature displayed reflects actual
temperature inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set point before
loading.
Approximate time required (empty unit) when converting
between refrigerator and freezer:
• 30ºF to 0ºF - 1 hour
• 0ºF to 38ºF - 4 hours
CLEAR ICE AND NUGGET ICE MACHINES
Initial startup requires no adjustments. See CONTROL
OPERATION section for more details.
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factor default settings. If the unit was turned off during
installation, simply press and the unit will immediately
switch on. To turn the unit off, press and release.
Defrost
This unit requires manual defrost, periodically.
Inspect the interior walls for frost build up every 3 - 4
weeks. Defrost your unit when 1/4” of frost builds up
on the interior walls. Frost will build up faster in humid
environments and when the door is opened frequently.
To defrost, remove ice bucket, turn off unit, leave door
open, and allow frost/ice to melt naturally. Do not use
tools to chip or scrape the frost as it may damage your
unit. Use a towel to absorb melting frost/ice. Before
turning the unit back on, make sure all the frost is gone
and the unit is dry.
