0415 IH-2709
PAGE 7 OF 8
TOTALIZE
Totalize is enabled only when Total is turned ON in the
Mode submenu in the .S.E.T.U.P. menu. Totalize allows
storage of a series of weight measurements. Totalize
mode has been initiated when "t" and the current unit,
i.e., (g) is displayed. When totalized weight is shown,
the "t" indicator will blink.
NOTE: Units cannot be changed when in
display hold mode.
Total weight will remain on the display until weight is
removed. The total weight remains in memory. Total is
limited to 999999.
CLEAR/EXIT TOTALIZE
Performing this step will erase all totalized memory.
ADDITIONAL FEATURES
WEIGH BELOW
Scout Pro permits below
balance weighing for
applications such as
specific gravity/density
determination. The
balance is normally
elevated, supported on
all feet and leveled. A
fine wire is attached to
the built-in hook at the
bottom of the balance
LOCK SWITCH
The Lock Switch is located under the balance. The Lock
Switch is used to lock out the menu mode preventing
unauthorized changes.
To lock the menus, position the Lock Switch next to the
tab on the bottom of the balance as shown.
1
1
(Place first weight
on platform)
(Place second
weight on platform)
(Remove weight)
1
(Total weight shown)
(Remove weight)
(Place third weight on platform)
1
(Total weight shown)
(Remove weight)
3
Weigh
Below
Hook
Locked position
Unlocked
OPERATION CONTINUED
MAINTENANCE
CLEANING
To ensure proper balance operation, keep the housing
platform clean. If necessary, a cloth dampened with a
mild detergent may be used. Check under the platform
for debris and remove.
NOTE: Keep calibration masses in a safe, dry
place. Unplug the AC Adapter when not in use.
For long term storage, remove the batteries.
