8
u-line.com
Custom 1/4" Drawer Panel Inserts
Drawer Panel Preparation
Custom drawer panels can be inserted into the drawer fronts.
Custom drawer panels can be flat or raised, as long as the
maximum panel thickness where inserted into the drawer front
reveal (channel) is 1/4"-thick. For raised panels, the depth of the
reveal is 1/4" on all four sides.
NOTICE
Raised panels will reduce the drawer’s front clearance if
the unit is installed facing an appliance or structure (see
page 5).
Cut the panel inserts to the following dimensions.
Custom 1/4" Dimensions:
Width:
23-1/32"
Height:
12-15/32"
The door panels must not have a total weight of more than 20 lbs.
Drawer Panel Installation
Install the insert as follows:
CAUTION
!
Use care when handling the insert. Insert edges may be
sharp.
1. Open drawer. Pull drawer gasket
out of groove (top edge of drawer
only). Start in the middle and pull
outward, moving toward the edge .
This may take some force.
2. Remove and save the two outside
screws.
3. Remove the original handle and
discard.
4. Remove and discard existing panel
and cardboard spacer.
5. Slide custom drawer panel insert
into 1/4-inch channel in drawer
front.
6. Holding drawer gasket out of the
way, replace handle on drawer,
making sure it is seated properly on
insert and that screw holes line up.
7. Install two small screws removed in
Step 2.
8. Starting at the corners and working
inward, push drawer gasket into
place on drawer.
Full Overlay Drawer Panel
Drawer Panel Preparation
A full overlay drawer panel completely covers the drawer frame
and handle to give you a built-in appearance.
NOTICE
• The drawer panel must not weigh more than 10 lbs.
• It is important to ensure that all drilled holes are drilled
to the correct depth in order to avoid splits in the wood
when hardware is installed.
• Appliance will need up to 34-1/2" to the under side of
the counter to leave room for leveling adjustments.
1. Determine cabinet toe kick height, measure the difference
between the surface the appliance will sit on and the bottom of
the adjacent cabinetry. Adjust lower panel height according to
the height of your cabinetry’s Toe Kick.
2. The upper overlay has a fixed width and height. Cut the upper
overlay to the dimension in the table below.
Upper Overlay
3. The lower overlay width is fixed at
23-3/4"
, and the height will
vary depending on the height of your cabinetry’s Toe Kick. Use
the table below to determine the proper height.
Note:
Dimensions will vary based on the levelness of the floor. If
floor is uneven, cut panel to the next longer dimension and adjust
level legs to achieve proper fit.
Lower Overlay
1. If user-supplied cabinet handles or knobs will be used, attach
this hardware to the overlay panel at this time.
NOTICE
User-supplied cabinet handles MUST be counter-bored to
make sure mounting hardware is below surface of overlay
panel. Failure to do so can cause damage to overlay panel.
7 Drawer Panel Installation
Height
Width
14-3/4"
23-3/4"
Toe Kick
Height
Toe Kick
Height
3-3/4"
14-3/4"
4-1/4"
14-3/8"
3-7/8"
14-3/4"
4-3/8"
14-1/4"
4"
14-5/8"
4-1/2"
14-1/4"
4-1/8"
14-1/2"
Gasket
Handle
Screw
Full Handle
Standard
Handle
