SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
USER GUIDE
u-line.com
5. Align top of panel with top edge of door. Center
panel on door. (For 3036/3090 models, align panel
on the hinge side-edge of door.)
NOTICE
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
flush with the top of the door.
6.
Secure integrated
panel to door using
clamps. A robust
tape may also be
used.
U-Line
recommends the
use of bar clamps
to secure the panel
to the door. If
using
tape
will
not
damage
panel
finish
upon
removal.
7.
Using a 7/64"
(3 mm) drill bit,
drill 6 pilot holes
into
the
wood
panel 1/2" (12
mm) deep using
the holes in
the
door
frame
as
a
guide.
10.Ensure the screws sit flush against the bottom of
the channel.
Integrated Panel
Integrated Panel
11.Remove clamps from door.
1. Fully open door.
NOTICE
It is important to ensure that all drilled holes are
4. Upon removal, lay gasket down on a flat surface.
9. Using a Phillips screwdriver, place one screw into
each of the 6 pilot holes and screw down. Do not
overtighten
Integrated Panel Installation
drilled to the correct depth in order to avoid splits in the wood when hardwood is
installed.
2. Starting at corner, pull gasket away from door.
8. Locate 6 of the #6x 1-1/2" (38 mm) screws provided with your unit. 3. Continue to pull gasket
free from gasket channel.
screws.
Summary of Contents for U-3018RINT-00A
Page 42: ...USER GUIDE u line com Extended Non Use 1...
Page 51: ......
