QUICK START GUIDE
11
USER GUIDE
u-line.com
Control Operation
Control Operation
CONTROL FUNCTION GUIDE
FUNCTION
COMMAND
NOTES
ON/OFF
Press and release
Unit will immediately turn On or OFF
Leave interior light on
Press and release to leave interior
light on for 12 hours; press again to
deactivate
After 12 hours, factory default is restored; light will
turn on when door is open
Adjust Refrigerator
Temperature
Press or and release
When the display is flashing, press or to
adjust the set point temperature. Note: temperature
displayed is the actual temperature inside unit
Toggle between ºF / ºC
Hold and for 5 seconds
The display will change units
Enable Sabbath Mode
Press and hold for 5 seconds and
release
The oF / o
C symbol will flash briefly after 5 seconds.
Interior light and display will go dark and remain so
until user resets mode - unit continues to operate
Disable Sabbath Mode
Press
and release
Display and interior light return to normal operation
Showroom Mode
Hold and for 5 seconds
Display will show
SH
for 2 seconds. Interior light and
display will function normally, but the compressor
and fans will not energize.
Repeat command to return to normal operation.
Display will show
EH
for 2 seconds.
This unit is Star-K certified. See
www.star-k.org for more details.
DOOR ALERT NOTIFICATION
When the door is left open for more than 5 minutes:
•
A tone will sound for several seconds every minute
•
will appear in display
Close door to silence alert and reset
Temperature displayed reflects actual
temperature inside unit.
Initial startup requires no adjustments. When plugged
in, the unit will begin operating under the factory default
settings. If the unit was turned off during installation,
simply press and the unit will immediately switch on. To
turn the unit off, press .
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set points before
loading.
NOTICE
First Use
