USER GUIDE
Cleaning
u-line.com
NOTICE
Use only U-Line Ice Machine Cleaner (Part No.
80-54081-00), available from your dealer or
direct from your local parts distributor. To locate
a parts distributor near you, visit
u-line.com
. It
is a violation of federal law to use this solution in
a manner inconsistent with its labeling. Use of
any other cleaner can ruin the finish of the
evaporator and will void the warranty. Read and
understand all labels printed on the package
before use.
U-Line Ice Machine Cleaner is used to remove lime scale
and other mineral deposits. Refer to the following steps to
initiate the self-cleaning cycle.
CAUTION
!
Never use anything
to force ice from the
evaporator. Damage
may result.
1. Turn the ice
machine off and
allow any ice to melt
off of the
evaporator.
2. Remove all ice from the storage bin.
3. Remove evaporator cover.
4. Remove the standpipe by lifting it up while using a
slight back and forth motion to loosen it from the drain
hole. The water in the reservoir will flow down the
drain.
5. Re-install the standpipe into the water trough.
6. Clean the Interior Bin as follows:
• Dilute one packet of CLR cleaner into two quarts of
water.
• Using a sponge or cloth, clean interior of ice bin,
tubing and door. This cleaner will remove all mineral
deposits and other contaminants from the surfaces.
• Using a bottle brush, clean out the trough drain tube
and pump tubing where needed.
7. Turn unit on by pressing .
8. Place the unit into CLEAN mode by holding
for
5 seconds.
Evaporator cover
Standpipe
Evaporator
Water trough
Brush
25
