USER GUIDE
u-line.com
Cleaning
Under normal conditions cleaning should be done
when the display shows
CL
. You may initiate a
cleaning cycle at any time by pressing and holding
the clean button for 10 seconds.
0 1
will appear
in the display indicating the start of the cleaning
process.
Failure to clean may reduce the quality and quantity of ice
produced. Once the clean cycle begins, it can be canceled
by pressing three times. Press once more to start
making ice. The clean cycle will automatically cancel if user
fails to activate control at steps 2, 3b, and 5b within 2 hours.
Required for cleaning:
• Clean potable water
• Bucket and cleaning sponge
•
Internal water filter (if applicable) —
ULANUGGETFILTER**
•
SafeCLEAN Plus™ Cleaner — ULANUGGETCLEAN**
•
Hose (7⁄16
” ID x
9⁄16” OD) and funnel
◦
Register your product at u-line.com and receive
a free cleaning kit - ULANUGGETCLEANKIT**
(cleaner, hose, & funnel)
** available for purchase at u-line.com or your local dealer
Need more cleaner? Visit u-line.com
CAUTION
!
Use only SafeCLEAN Plus™ Cleaner. Use of any
other cleaner may damage the finish of the
evaporator and will void the warranty.
Follow safety and handling instructions printed on
the SafeCLEAN Plus™ bottle.
Notice:
Select models include a water filter. The filter
must remain in place when using and cleaning
the machine. The filter is designed to filter out
scale, sediment, particles and cloudiness as well
as reduce chlorine and other off tastes and odors.
U-Line recommends replacing the filter (Part No.
ULANUGGETFILTER) when you clean your machine.
The filter is available at u-line.com.
1. Press and Hold for 10 seconds
a.
0 1
will appear in the display
b. Remove access shield
c. Remove all ice in bin
d. Remove any ice protruding from the ice dispenser
tube.
2. Insert the end of the cleaning tube into the ice
dispenser; slowly pour in approximately 1 quart of
hot (min. 100º F) potable water. This will melt ice
inside the dispenser tube. It is normal for some water
to flow from the ice dispenser tube and exit from the
vent tube while pouring. Omit this step if no ice is in
the ice dispenser tube.
3. Press and release
a.
02
will appear in the display
b. Mix 4 ounces of SafeCLEAN Plus™ with 2 quarts of
potable water.
4. Wait until
03
appears in the display
a. Using the funnel and cleaning tube, slowly pour
3⁄4
of the cleaning solution into the dispenser
tube. Air and some water will exit the vent tube.
Remove cleaning tube. (Optional - for deeper
cleaning, allow solution to soak for 60 minutes)
b. Press and release
5
.
04
will appear in the display
a. The machine will circulate the solution, cleaning
and sanitizing the internal components, for
approximately 20 minutes.
b. While the machine is circulating the cleaning
solution, use
1⁄2
of the remaining cleaning solution
and a sponge to wipe down the inside of the ice bin
and scoop. Rinse with clean potable water.
Cl
Cleaning Tube
and Funnel
Ice
Dispenser
Tube
Vent Tube
24
