PAGE 5 OF 18
0518 IH-6323
PRINTING A TEST LABEL
NOTE: Before you connect the printer to
computer, make sure the printer is in proper
working order.
PRINT A CONFIGURATION LABEL
1. Make sure the media roll is properly loaded and the
top cover of the printer is closed.
2. Turn the printer power on.
3. Once the printer is in the ready state (indicator is
solid green), press and hold the FEED and CANCEL
buttons for two seconds and release.
4. The Printer and Network Configuration Reports will be
printed. (See Figure 6)
Figure 6
CLEANING PRINTER
NOTE: Adhesives and media material over
time can transfer onto the printer components,
including the platen and printhead. This
buildup can accumulate dust and debris.
Failure to clean the printhead, media path
and platen roller could result in inadvertent loss
of labels, label jams and damage.
NOTE: Using too much alcohol can result in
contamination of the electronic components
requiring a longer drying time before the
printer will function properly.
When cleaning the printer, use one of the following
supplies:
CLEANING SUPPLIES
QUANTITY PURPOSE
Cleaning Pens
(105950-035)
12
Clean Printhead
Cleaning Swabs
(105909-057)
25
Clean media path,
guides and sensors
To clean the printhead:
• Let the printhead cool for a minute, then use a new
cleaning pen to swab the dark line on the printhead.
Clean from the center to the outside edges of the
printhead.
• Repeat after every roll of media.
To clean the platen roller:
• Remove the platen roller, then clean the roller
thoroughly with 90% medical-grade alcohol and a
cleaning swab or lint-free cloth.
• Repeat as needed.
To clean the peel bar:
• Clean thoroughly with 90% medical-grade alcohol
and a cleaning swab or lint-free cloth.
• Repeat as needed.
To clean the media path:
• Clean thoroughly with 90% medical-grade alcohol
and a fiber-free cleaning swab.
• Repeat as needed.
To clean the exterior:
• Wipe with a water-dampened cloth.
• Repeat as needed.
To clean the interior:
• Gently brush out printer.
• Repeat as needed.
