10
ASSEMBLY
STEP 3: CONNECTING ARM ASSEMBLY
1.
Align the hole in the end of the Connecting arms (L&R)(7&8)(pivoting rod end) with the
hole in the bracket of the Lower Handle Bars (L&R)(3&4). The rod end should be on the
inside of the Lower Handle Bars (L&R)(3&4) bracket. Take 2pcs of 5/16"
×
32m/m Hex
Head Bolts (71) and install it through the Lower Handle Bars (L&R)(3&4) bracket and
the rod end. Install 2pcs of 5/16"
×
20
×
1.5T Flat Washers (98), 2pcs of 5/16"
×
7T
Nyloc
Nuts (105) tighten firmly using the 12m/m Wrench (111) on the 5/16"
×
7T
Nyloc
Nut (105) and one on the 5/16"
×
32m/m Hex Head Bolt (71).
2.
Install the 2 pcs of Rails (15) into the receiving bracket in the end of Main Frame (1) with
2 pcs of 3/8"
×
2-1/4" Button Head Socket Bolts (77), 2pcs of 3/8"
×
19
×
1.5T Flat
Washers (94) and 2 pcs of 3/8"
×
7T
Nyloc
Nut (89) by using 2 pcs of the 13/14m/m
Wrench (111).
3.
Put the Lug Covers (L&R) (61& 62) onto the Rail Strap (16). Slip the Rail Strap (16)
through the slots in the Lug Covers (L&R) (61& 62), then Install onto the Rails (15) with
2 pcs of 5/16
"
×
3/4
"
Button Head Socket Bolts (76) and 2 pcs of 5/16"
×
20
×
1.5T Flat
Washers (98) by using Combination M5 Allen Wrench & Phillips Head Screw Driver
(108).
STEP 4: PLASTICS ASSEMBLY
4.
Install the Connecting Arm Covers (L & R) (59 & 60) over the connection of the rod end
and Lower Handle Bars (4 & 5) with 4pcs of M5
×
15m/m Phillips Head Screws (79) and
2pcs of Ø3.5
×
12m/m Self Tapping Screws (84) by using the Combination M5 Allen
Wrench & Phillips Head Screw Driver (108).
1.
Install the 2pcs of Wheel Covers (52) using the 4pcs of M5
×
15m/m Phillips Head
Screws (79).
3.
Install the Front Handle Bar Cover (L & R) (54 & 56) and Rear Handle Bar Cover
(L & R) (55 & 57) over the
Handle Bars (13&14)
axle connections with the 6 pcs ofØ3.5
×
12m/m Self Tapping Screws (84) by using Phillips Head Screw Driver (108).
PLEASE ENSURE ALL FASTENERS ARE TIGHT AFTER THE COMPONENTS
HAVE BEEN ASSEMBLED.
