17
Service maintenance
Return to factory settings
To return to factory settings:
1.
De-power repeater
2.
Press and hold FUNC button
3.
Supply power to repeater
4.
Wait for 10 seconds, until LED diode lights and release FUNC button
5.
LED diode will flash 6 times that means factory settings restored
Switching to programming mode
To switch repeater into the programming mode do the following:
1.
Do not turn off the power.
2.
Open enclosure
3.
Connect cable to the USB and configure the device using the software
"Configurator"
Replacing the device firmware
1.
De-power the repeater
2.
Remove the top cover of repeater
3.
Connect the notebook with USB cable to the repeater
4.
Using special software, do the replacement of repeater firmware
5.
After downloading the software to the access control repeater WAIT for or
40-50 seconds. (If readers are connected wait for 6 short beeps)
Factory settings
Communicatior
Wi-Fi is not set, DHCP enabled (no device IP set), no server set
