4
Brief description of the repeater
U-PROX HW repeater - a device designed to extend the range of the wireless
subsystem of U-Prox IP access control system.
Repeater operates with U-Prox IC L access control panel and U-Prox IP500 wireless
battery powered escutcheons.
Wi-Fi (wireless LAN) used for U-Prox HW connection to U-PROX IC L.
The network settings of the repeater programming and firmware upgrade performed
via a standard USB port (micro USB B).
U-Prox HW supports power supply external 12V DC (+E, GND) or standard micro
USB power supply adaptor
Intended use
U-PROX HW repeater is designated for work in U-Prox access control system for
U-PROX IP500 control panel network range extension.
Summary
Power:
o
External power supply
, 12V:
Current consumption max 150 mA @ 12V
Maximum voltage ripple 500 ma peak to peak
o
Micro USB B
standard power supply
Direct operation with U-Prox IP500 panels
o
ISM band device with bi-directional communication
ITU Reginon 1 (EU):
868.0-868.6 MHz
ITU Reginon 2 (USA):
902.5-914.5 MHz
ITU Reginon 3 (AUS):
915.5-927.5 MHz
o
Guaranteed range of 20 m
o
U-Prox IC L connection interface
– wireless computer network Wi-Fi
One micro USB B port for network settings configuring and firmware upgrade
Communication interface IEEE 802.11b/g/n (Open, WPA-PSK, WPA2-PSK)
Adjusted with U-Prox IP software. Supports automatic configuration for one-range
network.
Overall dimensions of device enclosure
– 120 х 40 х 355 mm
Temperature range: 0 - +55
0
C at 80.% relative humidity.
Maximum relative humidity 80% without condensation
