Chapter 4. Function Operation
23
8-3. Button Beep
This setting will allow you to set up to hear a beep when a button is pressed or not.
8-4. Eject On Start
You can make the trays or discs eject once the system is booted up.
⃝
Eject All Discs: To eject all trays with disc inside once the system is booted up.
⃝
Do Not Eject: No eject any tray or disc once the system is booted up.
⃝
Eject Target Only: Only eject target trays with disc inside once the system is
booted up.
⃝
Eject Source Only: Only eject source disc once the system is booted up.
⃝
Eject All Trays: To eject all trays once the system is booted up.
8-5. Reader Speed
This setting allows you to adjust the reading speed of source drive. The default
setting of reader speed of CD is 40
╳
; DVD is 24
╳
.
8-6. Compare Speed
The reading speed of drive and disc are the reasons can affect the quality of
comparison. This setting allows you to adjust the reading speed of drives to match
up the reading speed of discs. The default setting of CD’s compare speed is 40
╳
,
DVD is 8
╳
.
8-7. Language
You can set a proper language for interface during operation.
8-8. Clear Setup
This setting will reset all the function back to manufacturer’s default setting.
8-9. Advanced Setup
⃝
Power On Time: You can set a warm-up time from 5 to 99 seconds for warming
up the duplicator when it is turned on. The default setting is 10 seconds.
⃝
Start-up Menu: You can select which function you would like to show up in the
beginning.
Summary of Contents for BD18 SERIES
Page 1: ...BD18 SERIES Blu ray DVD CD Duplicator Controller User Guide V6 20...
Page 34: ......
Page 35: ......
Page 36: ......
