18
➢
CFast-Native(CFN) Series
4.1 H2 Test
This function performs a read and write test to determine the flash’s quality
. After H2 Test,
the device will contain H2 files which can be verify again through computer’s
software if
necessary.
4.2 H2 + Format
This function performs a read and write test to determine the flash’s quality
. After H2 Test,
it will execute format to delete the H2 files.
4.3 H5 + Format
This function performs a read and write test to determine the flash’s quality
. After H5 Test,
it will execute format.
4.4 Setup Range %
This function sets the quality check capacity range. Use the
▲▼
buttons to set the range
from 1 to 100%. The higher the percentage, the longer it takes.
4.5 Setup Range MB
This function sets the quality check capacity range in MB. Use the
▲▼
buttons to set the
range from 1MB to 9000MB.
Note
The duplicator will abide by whichever was set last if both Range% and
Range MB are set.
4.6 Setup Error Limit
This function sets the error tolerance range while checking the flash. Use the
▲▼
buttons
to set the error limit value. Select units to use (KB or MB), then select the value.
[Setup Range]
100%
[Setup Range MB]
2000MB