2
Function Table
10
4. Advanced
4.4 Utility
4.4.4 Quick Erase
To erase the content of flash media. It will keep the FAT format.
4.4.5 Full Erase
To completely bit for bit erase data of flash including format and
content, but it takes more time.
4.4.6 System Update
System firmware updating via the flash media.
4.4.7 Calc. Checksum
Calculate the CRC64 value of the flash media in the source port.
4.4.8 A2 Fake Picker
To check if an USB flash contains fake capacity.
4.5 Setup
4.5.1 Copy Area
4.5.1.1 System and Files
The system can automatically analyze the
format of source data and only copy the
data area.(Available for FAT16/32, NTFS,
Linux (ext2/ext3/ext4) )
4.5.1.2 Whole Media
The system will copy the whole content of
flash including the empty space.
4.5.2 Button Sound
To choose whether to hear a beep or not when a button is
pressed.
4.5.3 Target Tolerance
To set the tolerance % of capacity gap between the source and
target. The default setting is “No limit”.
4.5.4 Asynchronous
“Enable” to open Asynchronous function, “Disable” to close the
function.
4.5.5 Check Before Copy
To set if you would like to check the flash media before copy.
4.5.6 Power Off Time Between Copy&Compare
To set the power-off time between Copy and Compare when
executing “Copy+Compare” function.
4.5.7 Auto Start After Fill Device
To set if immediately start “copy/compare” tasks once plug-
ging in all targets.
4.5.8 Language
Set system language interface i.e. English, Japanese.
4.5.9 Select Speed
To select the speed of data transmission among “Fastest”,
“Faster”, “Normal”, “Slower”, and “Slowest”.
4.5.10 Set HDD Mode
Set if you would like to copy USB-HDD or USB drives only.
4.5.11 Advanced Setup
To change LED mode to “Traditional” or
“Factory” mode (both on/both off).
LED in Factory-
Mode
