4
Function Overview
21
4.2 Media Check
❶
The function is to analyze flash’s quality. There are 3 methods to do media check, "4.2.1
H3 Safe", "4.2.2 H5 RW" and "4.2.3 H6 SafeRW 100%". Before executing quality check,
user can go to function "4.2.4/4.2.5 Setup Range","4.2.6 Setup ErrorLimit" and "4.2.9
Set Capacity Limit" to finish setting.
❷
This function also provides speed measuring. Using the settings of "4.2.7 Minimum Read
Speed" and "4.2.8 Minimum Write Speed", users can pick out the flash which speed is
lower than your minimum setting.
4.2.1 H3 Safe 100%
This function is to check the flash’s quality by reading the flash media. After executing the
function, it will show the volume of bad sectors and also the reading speed of the flash
device.
When processing, user can use
▲▼
buttons to check the status for each port.
Bad sector
Reading speed
Test area
Note:
1. This function will not change the content or format.
2. You can set the checking range % at "4.3 Setup Range".
4.2.2 H5 RW 100%
This function is to check the flash’s quality by reading and writing the flash media. After
executing the function, it will show the volume of bad sectors and also the reading/writing
speed of the flash device.
When processing, user can use
▲▼
buttons to check the status for each port.
Bad sector
Reading speed
Writing speed
Test capacity
Note:
1. This function will change the content and format of flash media, please do not execute this function if there is
important data in it.
2. To protect source data, the system will not execute this function on the master device.
