23
111299-06 - 9/22
SteamMax
Knock-Down Assembly Instructions
CAUTION
Use proper Personal Protective Equipment (PPE)
during assembly.
10
Single Jacket Assembly
See Figures 10-1, 10-2 and 10-3 for References.
1. All jacket panels attach using black square drive
# 8 metal screws.
2. Rear and side panels have flanges which rest on
base to facilitate assembly.
3. Attach rear jacket panel,
Item 1
, to base tray.
4. Attach left side jacket panel,
Item 2
, to base tray
and rear jacket panel.
5. Attach right side jacket panel,
Item 3
, to base tray
and rear jacket panel.
6. Attach vestibule panel,
Item 4
, to side jacket
panels.
Figure 10-1: Single Jacket Assembly
1
3
2
4
NOTICE:
Do not attach top panels until wiring is
complete.
7. Attach front top jacket panel,
Item 5
, to side
jacket panels.
8. Attach rear top jacket panel,
Item 6
, to side jacket
panels.
9. Attach tie bar,
Item 7
, to side jacket panels.
10. Install rear air dam,
Item 9
, by hanging it on
stand-offs on base tray.
WARNING
This installation is not complete until rear air
dam is installed. Product performance will be
negatively affected if rear air dam is not installed
which can cause severe personal injury or
death.
NOTICE:
Do not install front door until wiring is
complete.
11. Install front door,
Item 8
.
!
!
