25
111299-06 - 9/22
SteamMax
Knock-Down Assembly Instructions
Figure 10-3: Rear Air Dam Installation
CAUTION
Use proper Personal Protective Equipment (PPE)
during assembly.
11
Dual Jacket Assembly
See Figures 11-1, 11-2 and 10-3 for References.
1. All jacket panels attach using black square drive
# 8 metal screws.
2. Rear and side panels have flanges which rest on
base to facilitate assembly.
3. Attach left rear jacket panel,
Item 1
, to base tray.
4. Attach left side jacket panel,
Item 2
, to base tray
and left rear jacket panel,
Item 1
.
5. Attach right rear jacket panel,
Item 3
, to base tray
and left side rear jacket panel,
Item 1
.
6. Attach right side jacket panel,
Item 4
, to base tray
and right side rear jacket panel,
Item 2
. Panel
has a lip which rests on the base tray to facilitate
assembly.
7. Attach jacket upper bracket,
Item 5
, on left side
of section assembly joint between canopies using
3/8-16 bolt, washers and nut.
8. Attach left side vestibule panel,
Item 6
, to left side
jacket panel,
Item 7
, jacket upper bracket,
Item 5
,
and jacket lower bracket.
9. Attach right side vestibule panel,
Item 7
, to right
side jacket panel,
Item 4
, and left side vestibule
panel,
Item 6
.
NOTICE:
Do not attach top panels until wiring is
installed.
10. Attach top front left side jacket panel,
Item 8
,
to left jacket panel,
Item 2
, and jacket upper
bracket,
Item 5
.
11. Attach top front right side jacket panel,
Item 9
, to
right jacket panel,
Item 4
, and top front left jacket
panel,
Item 8
.
12. Attach top rear left side jacket panel,
Item 10
, to
top left jacket panel,
Item 2
, and top front left side
jacket panel,
Item 8
.
13. Attach top rear right side jacket panel,
Item 11
, to
top right jacket panel,
Item 4
, and top front right
side jacket panel,
Item 9
.
14. Attach left tie bar,
Item 12
, to left side jacket
panel,
Item 2
, and jacket lower bracket.
15. Attach right tie bar,
Item 13
, to right side jacket
panel,
Item 4
, and left tie bar,
Item 12
.
16. Install right rear air dam,
Item 16
, by hanging it on
stand-offs on right side of base tray.
17. Install left rear air dam, not shown, by hanging it
on stand-offs on left side of base tray.
WARNING
This installation is not complete until rear air
dams are installed. Product performance will
be negatively affected if rear air dams are not
installed which can cause severe personal injury
or death.
NOTICE:
Do not attach front doors until wiring is
completed.
18. Install left side front door,
Item 14
.
19. Install right side front door,
Item 15
.
!
!
