12.
THE WINCH IS NOT DESIGNED TO ACCOMMODATE ROPE OR STEEL
CABLE.
13.
THE STRAP/HOOK MUST BE PULLED STRAIGHT IN.
Keep the load in line
with the Winch. Pulling at an angle (off to the side) may cause excessive stress
on the Winch.
14.
DO NOT LEAVE THE WINCH UNATTENDED WHILE IT IS UNDER A LOAD.
15.
IF THE WINCH CANNOT BE CRANKED WITH ONE HAND, THE WINCH IS
PROBABLY BEING OVERLOADED.
CUT-AWAY SIDE VIEW
Ratchet Pawl Engaged
Ratchet Pawl Disengaged
FIGURE A
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List (page 8)
are
included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional references to the parts listed below, refer to the
Assembly Diagram (page 9).
To Mount The Winch On A Trailer Tongue:
1.
Place the Plate/Tube Assembly (part #1) on the top edge of the trailer beam with
the two mounting holes on each side of the Plate overhanging both sides of the
trailer beam.
(See Figure B, next page.)
SKU 2755
PAGE 5
Brought To You By Augusta Flint