SKU 66786
for technical questions, please call 1-800-444-3353.
Page 8
pressure, and release the throttle
and/or turn the switch to its off posi-
tion to prevent accidental operation.
note:
Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
oPERaTing inSTRucTionS
Read the EnTiRE imPoRTanT
SafETY infoRmaTion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
inspect tool before use, looking
for damaged, loose, and
missing parts. if any problems
are found, do not use tool until
repaired.
Tool Set up
To PREVEnT
SERiouS injuRY
fRom accidEnTal
oPERaTion: close the Ball
Valve, detach the air supply,
safely discharge any residual
air pressure in the tool before
performing any inspection,
maintenance, or cleaning
procedures.
To PREVEnT SERiouS
injuRY: do not adjust or
tamper with any control or
component in a way not
specifically explained within
this manual. improper
adjustment can result in
tool failure or other serious
hazards.
Work Piece and Work area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the air hose along a safe route
2.
to reach the work area without creat-
ing a tripping hazard or exposing the
air hose to possible damage. The air
hose must be long enough to reach
the work area with enough extra
length to allow free movement while
working.
There must not be hazardous ob-
3.
jects (such as utility lines or foreign
objects) nearby that will present a
hazard while working.
general operating instructions
Open the Ball Valve (6) by turning
1.
Valve’s handle to a vertical position.
Unscrew Lock Knob (3) and readjust
Bowl (1) height.
Once the Bowl (1) has been set at
2.
the required height and locked into
place, remove oil pain plug to drain
the oil.
WaRning!
3.
Do not fill the Tank be
-
yond its 20-gallon capacity. The
discharge hose is clear, so the oil in
the tube will indicate the reservoir
