9.
Check for damaged parts
. Before using any product, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and
any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician.
10.
Stay alert
. Watch what you are doing, use common sense. Do not operate any tool when you
are tired.
11.
Replacement parts and accessories
. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty. Only use accessories intended for use with this
tool. Approved accessories are available from Harbor Freight Tools.
12.
Do not operate product if under the influence of alcohol or drugs
. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there
is any doubt, do not operate the product.
13. Do not allow people to sit on or ride on the Tool and Service Cart.
Warning:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be
supplied by the operator.
Assembly
Your Tool and Service Cart will require complete assembly prior to use. It is important that you read
the entire manual to become familiar with the product BEFORE you assemble and use the Tool and
Service Cart. Before assembling the Tool and Service Cart be sure that you have all parts
described in the Parts List and Assembly Diagram located at the end of this manual.
Step 1)
Attach the Bottom Shelf (#4) to one of the four (4) Vertical Support Columns (#11).
Place one Vertical Support Bracket (#6) onto the inside corner of the Bottom
Shelf (#4)-see Figure 1. Set one Vertical Support Column into the corner of the
Bottom Shelf (#4). Insert one Pan Head Machine Screw (#2) through each hole in
the bottom of the Vertical Support Column (#11), through the Bottom Shelf (#4) and
into the Vertical Support Bracket (#6)-see Figure 1. Thread on Nut. Repeat for
the remaining three (3) Vertical Support Columns (#11) and Vertical Support
Brackets (#6).
SKU 90722
Page 3
Step 2)
At the top of the Vertical Support Columns (#11), attach one (1) Side Brace (#10) to
each of the two (2) sides. With the Side Brace (#10) facing inward, Insert one Pan
Head Machine Screw ( (#1) through each Vertical Support Column (#11) and through
the Side Brace (#10). Thread on Nut to secure-see assembly diagram and
Figure 2.
Figure 1
Bottom Shelf (#4)
Vertical Support
Column (#11)
Caster (#9)
Pan Head
Machine Screw (#2)
Vertical Support
Bracket (#6)
90722 Tool and Service Cart.p65
9/30/03, 11:22 AM
3
