Page 3
SKU 91960
For technical questions, please call 1-800-444-3353
9.
Stay alert. Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
10.
Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualified
technician.
11.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor
Freight Tools.
12.
Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
13.
Maintenance. For your safety, service and repairs should be performed regularly by
a qualified technician. Maintenance should be performed regularly.
Warnings Specific To The Motorcycle Lift
1.
Do not attempt to lift any load greater than the 1500 Lb. maximum capacity.
2.
Always use good quality hydraulic oil. Do not mix various oils, and make sure no
dirt or debris enters the hydraulic system.
3.
Once a motorcycle is elevated on the Lift, do not move the Lift around. The
wheels on the Lift are designed to move the Lift without a load.
4.
Lower the motorcycle slowly, in a controlled fashion. Never allow it to drop quickly.
5.
Never allow anyone to ride this Lift when it is being raised or lowered, or while it
is holding a motorcycle. Do not allow anyone to ride the motorcycle while it is being
raised.
6.
Keep onlookers and children a safe distance from the Lift during operation.
7.
Before lifting, use tie-down straps (not included) to secure the load.
8.
This is a lifting device only. It is not designed to support loads for extended periods of
time.
9.
Only operate the Lift on a flat, dry, level surface, capable of supporting the Lift
and the load.
10.
This lift is not to be used for any aircraft purposes.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
