HOLDING TANK LID
SWITCH PLATE
LID (RECOVERY TANK)
VAC INTAKE
LATCH (2)
DRAIN GATE
QUICK-DISCONNECT
CASTOR
VENT
WHEEL
VACUUM (1), PUMP (2)SWITCHES:
These switches are powered by cord #1. Switches are on when illuminated.
CARPET/UPHOLSTERY SWITCH (3):
This switch is also powered by cord #1. The carpet setting (down position) is high pressure
(approximately 300 PSI). The upholstery setting (up position) is low pressure (approximately
50 PSI with a K1 or V2 spray tip).
BYPASS SWITCH (4):
The bypass switch will illuminate when it is turned on, and it will completely bypass the circuit
locator system. Use this feature only when the circuit locator light will not operate and you
know each cord is on a separate circuit, otherwise a circuit breaker may trip.
CIRCUIT LOCATOR (5):
When this light is on, it indicates that cord #2 (identified by the red “H”) is on a separate line
from cord #1. Cord #2 supplies voltage to the heater.
PRIMING HOSE IN
POSITION FOR PRIMING
1
2
3
4
VAC 1
PUMP
CARPET
BYPASS
CIRCUIT
LOCATOR
5
UPHOLSTERY
