SET-UP:
Fill the holding tank with clear water and the detergent of your choice. Mix well.
1.
Plug in cord . (This cord runs the pump and vacuums).
2.
Turn on the pump and spray through the cleaning tool for a few seconds to fill the lines
with solution.
BALL FLOAT VAC SHUTOFF:
When the recovery tank is full, the float system will shut off the incoming air flow and prevent
water from entering the vacuum motors. The float may not work properly if the float ball cage is
clogged or if there is foam in the tank. Foam may not lift the ball float.
CAUTION: To avoid vac motor damage, always make sure the float cage is clean and
the ball travels freely before turning on the machine, and use a defoamer whenever
foam is present.
VACUUM SWITCH (1 & 2):
Each switch turns on one vacuum motor. Turn both switches on for maximum
lift. The switches illuminate when turned on.
PUMP SWITCH (3):
This switch turns on the pump. The switch illuminates when turned on.
1
2
VAC 1
VAC 2
PUMP
3
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
