1
Operation:
Before each use: if necessary, unscrew the stainless steel filter inside the recovery tank and clean
it. Also make sure the float in the recovery tank is clean.
•
Attach a 3/4” garden hose to the dump pump outlet fitting on the back of the base of the machine.
Refer to illustration below.
•
Run the other end of the hose into a drain.
•
Turn the dump pump switch ON (switch is located on the switch panel on the top of the machine).
•
NOTE: the dump pump will only run when the tank is full enough to activate the float switch.
•
NOTE: the pump is ‘self-priming.’ You should see water start to flow within 30 seconds of the
pump turning on. If water does not begin to flow, check the filter to see if it is plugged with debris.
After each job: run clear water though the dump pump to wash out any chemical residue.
Remove and clean the stainless steel filter in the back of the tank. Reinstall the filter once it is
clean. Clean and empty the recovery tank.
DANGER: DO NOT USE SOLVENTS, OR ANY CHEMICALS THAT MAY BE
FLAMMABLE, EXPLOSIVE OR COMBUSTIBLE.
CAUTION: always use a defoamer in the recovery tank to prevent water or foam from
entering the vacuum motor.
CAUTION: if the dump pump is not going to be used for a month or longer, remove the pump
impeller cover, pull the rubber impeller out, clean it and apply a generous coating of petroleum
jelly to the impeller before replacing it in the pump. Make sure the gasket is in place and in good
condition before you screw the impeller cover back on.
AUTO-DUMP
DANGER: always unplug the King Cobra from the electrical outlet(s) before
cleaning or maintaining. Certain internal components are electrically live,
even with switches in their OFF position.
Power
Prime
Hose
Dump
Pump
Power
Prime
Pedal
Power
Prime
Valve
AUTO-DUMP
Drain Hose
8
Summary of Contents for KING COBRA-1200 PRO 240V
Page 9: ...9 240V...
